Gamma Vacuum SPCe - Page 47

Hex
command
Description Data eld Response Data/Response description
69 GET HV
AUTORECOVERY
Displays the mode
of Auto Recovery.
n n = 0-2
0 = disabled
1 = enable auto HV restart
2 = enable auto power
recovery
8F SET_FIRMWARE_UPDATE
Sets the SPCe to
ash load mode for
rmware updates.
D3 SET COMM MODE
Sets the
communication
mode to local, full,
or remote.
N N is the mode 0 = Local
1 = Remote
2 = Full
D4 GET COMM MODE
Returns the current
communication
mode.
N N is the mode 0 = Local
1 = Remote
2 = Full
46 GET/SET SERIAL
COMM
Gets/Sets baud rate,
parity, data bits,
and stop bits. If no
parameters are
specied, the
current values are
returned.
None or
"B, P, D, S"
(set mode)
None or "B,
P, D, S"
(get mode)
B = baud rate
P = parity ("n", "e", "o") D =
data bits ("7", "8")
S = stop bits ("1", "2")
47 GET/SET ETHERNET
IP
Gets/Sets Ethernet
IP address. If no
parameters are
specied, the
current values are
returned.
None or
"X.X.X.X"
(set mode)
None or
"X.X.X.X" (get
mode)
48 GET/SET ETHERNET
MASK
Gets/Sets Ethernet
mask. If no
parameters are
specied, the
current values are
returned.
None or
"X.X.X.X"
(set mode)
None or
"X.X.X.X" (get
mode)
04/2021 - ©Gamma
Page 47900026_F
900026_F - Serial (J3) and ethernet (J2) operation