User module »DP-HR-U-CON-DH«
143 · Target and user modules (DP-HR-U)
User module »DP-HR-U-CON-DH«
With DP-HR-U-CON-DH user modules, you can connect up to two DisplayPort monitors
(dual-monitor), keyboard, mouse, microphone and speakers to a digital matrix
switch of the ControlCenter-Compact, ControlCenter-Digital or the DVICenter series by
using one cable only.
At the installed console, matrix switch users can access a target module to operate
the connected computer.
The data stream of the connected USB devices is transmitted to the active target
module of the
DVI-U-CPU, DP-U-CPU or DP-HR-U-CPU series with up to 16 Mbit/s.
When using the console to access a target module connected to a dual-head com-
puter, the monitors display the separate images of the graphics outputs. When
accessing a target module with one graphics input only, only the first monitor dis
-
plays an image.
Package contents
1 × User module DP-HR-U-CON-DH
1 × Power cable
1 × EasyStart flyer
1 × »Safety instructions« flyer
Required accessories
1 × Category 5e (or better) twisted pair cable to connect the user module to a
KVM matrix switch
ADVICE:
If you use the first video channel only, you are able to display resolutions
up to 4096
× 2160 @ 30 Hz (4K). Using both video channels allows resolutions up
to 1920
× 1200 @ 60 Hz. Detailed information about the supported resolutions is
given in the chapter
Technical data on page 148.
NOTE:
Accessing a target module occupies the entire back channel (including Micro In
and USB 2.0 signal). Hence, these signals are not provided to the user modules that
access the channel at a later point (multi user operation).
To Next Page
Loading...
Need help?
General
