WARNING
Failure to observe these notices could result in damage to equipment.
●
●
●
●
●
Stop the unit if any repairs or adjustments on or around the compressor are
required.
Disconnect the compressor unit from its power source, tag and lockout be-
fore working on the unit
- this machine is automatically controlled and may
start at any time.
An Excess Flow Valve should be on all compressed air supply hoses ex-
ceeding 1/2 inch inside diameter. (OSHA Regulation, Section 1926.302)
Do not exceed the rated maximum Pressure values shown on the nameplate.
Do not operate unit if safety devices are not operating properly. Check peri-
odically. Never bypass safety devices.
13-9/10-641 Page 5
To Next Page
Loading...
Need help?
General
