Page 85
14) Press YES. The display will show for example:-
(for Novagard Active battery)
15) Press YES. The display will show for example:-
(for Novagard Active battery)
16) Press YES. The display will show for example:-
(for Novagard Active hold-off volts)
17) Press YES. The display will show for example:-
(for Novagard Active sounder current)
18) Press YES. The display will show for example:-
(for Novagard Active strobe current)
19) Press YES. The display will show for example:-
(for Novagard Active charge current)
20) Press YES. The display will show for example:-
(for Novagard Active quiescent current)
21) Press YES. The display will show for example:-
This concludes the Diagnostic Tests. To Escape
Press 0 until the display shows:-
Note: If battery test is programmed other than 00 a battery test will be
performed each time you escape from engineer mode.
On-Charge (V) =
9.6
On-Charge (V) =
8.4
Hold-Off (V) =
13.6
Bell (mA) =
270
Strobe (mA) =
109
Charge (mA) =
10
Static (mA) =
25
Fault Status =
00
< < < < UN-SET > > > >
01 Jan 00: 00: 01
GardTec 872
Miscellaneous
To Next Page
Loading...
