Garmin Pilot for iOS User’s Guide
190-01501-00 Rev. F
154
Subscriptions
OverviewPlanFileFlySubscriptionsAppendicesIndex
SAFETAXI
SafeTaxi is an enhanced feature that gives an airport diagram with greater map
detail. The maximum map ranges for enhanced detail are pilot-configurable. SafeTaxi
diagrams showing taxiways with identifying letters, runway numbers, airport Hot Spots,
and airport landmarks including ramps, buildings, control towers, and other prominent
features. Resolution is greater at lower map ranges. When SafeTaxi is available for
an airport it will be displayed based on the Map zoom level and the SafeTaxi Visibility
Range set under
> Map/Chart > Map Theme > > Airports.
Designated Hot Spots are recognized at airports with many intersecting taxiways
and runways, and/or complex ramp areas. Airport Hot Spots are outlined to caution
pilots of areas on an airport surface where positional awareness confusion or runway
incursions happen most often. Hot Spots are shown as red outlined and shaded areas
on the SafeTaxi diagram.
Configuring the display of SafeTaxi
(Subscription Required):
1)
Touch > Map/Chart > Map Theme > > Airports.
2)
Under the Visibility Range heading, use the slider to configure the map
range at which SafeTaxi detail is displayed on the map.
3)
Under the Label Size heading, touch Off, Small, Medium, or Large
labels.
Viewing SafeTaxi
(Subscription Required):
From any page touch > , pull fingers apart or double tap
with one finger to zoom in on the desired airport.
NOTE:
SafeTaxi is only available on Maps (i.e., Road/Borders, VFR, or IFR).
SafeTaxi is not available on Charts; Sectionals/TAC, WAC, IFR Low, or IFR High.
To Next Page
Loading...
Need help?
General
