CHAPTER 1-Introduction
Specifications
DS2000-IFR Installation and Maintenance Guide
1-4
1.2.4 Compliance
* Certifications Pending
1.2.5 Power Requirements
The DS2000-IFR comes configured to be powered using AC or DC facility power. The DS2000-IFR is
available with a high voltage AC or DC power supply or a low voltage DC power supply. The power
requirements are listed in the table below, see Tab le 1 - 2 .
Safety
UL60950 EN60950 CE Mark CSA
Industrial
IEEE 1613
Emissions
EN55022A, FCC Part 15A VCCI, AS/NZ-3548
Immunity
EN55024-2003 EN61000-6-2 EN61000-4-2 (ESD) EN610000-4-3 (RF)
EN61000-4-4 (EFT) EN61000-4-5 (Surge) EN61000-4-6 (CRF) EN610000-4-11 (VDI)
Telecom
ACTA TIA/ESI IS-968A (Formerly FCC Part 15) EN55022:1998 Telco Port Emissions
Table 1-2. Power Requirements
Power Supply Options
Model
Voltage
Nominal
(V)
Voltage
Input Range
Power
(Watts)
Maximum
Amperage
(Amps)
High Voltage AC/DC 90/250
AC/DC
85 - 264
AC/DC
85 1.0
Low Voltage DC 24/48 DC 18 - 60 DC 81 4.5
To Next Page
Loading...
Need help?
General
