20 TROUBLESHOOTING
86
402136-10
Faults are indicated by malfunction indicator lamp
1
and by acoustic
signals that sound at the same time.
Tip
As a first measure for all faults, switch off the vehicle using the
On/Off button, wait 1 minute, and switch it on again.
If a fault is not eliminated by the measures specified here, or
a blink code is not listed, an authorized GASGAS Motorcycles
workshop will be happy to help you.
Info
The pause between the signals of the 1st digit is 0.25 seconds.
The pause between the 1st and 2nd digits is 1 second.
The pause between the signals of the 2nd digit is also 0.25 sec-
onds.
The pause until the blink code repeats is 3 seconds.
Faults Possible cause Action
Blink code 11 Fault in the throttle grip – Check the throttle grip for damage.
Blink code 12 Fault in the throttle grip – Check the throttle grip for damage.
Blink code 14 Throttle grip actuated during acti-
vation
– Do not operate the throttle grip during
activation.
Blink code 24 System temperature too high – Allow the vehicle to cool down, clean the
cooling surfaces.
Blink code 31 Fault during charging – Disconnect the battery charger from the
vehicle and mains connection, wait 1
minute, restart the charging process.
Blink code 33 System temperature too high – Allow the vehicle to cool down, clean the
cooling surfaces.
Blink code 34 System temperature too low – Park the vehicle in a warmer environment.
Blink code 41 Vehicle moved during activation – Do not move the vehicle during activation.
Blink code 42 Motor speed outside the permissi-
ble range
– Do not roll backward with the vehicle.
Blink code 43 System temperature too high – Allow the vehicle to cool down, clean the
cooling surfaces.
Blink code 71 Fault during charging – Disconnect the battery charger from the
vehicle and mains connection, wait 1
minute, restart the charging process.
– Replace the charging cable.
Blink code 72 Fault during charging – Disconnect the battery charger from the
vehicle and mains connection, wait 1
minute, restart the charging process.
– Replace the charging cable.
Blink code 73 Fault during charging – Disconnect the battery charger from the
vehicle and mains connection, wait 1
minute, restart the charging process.
– Replace the charging cable.
Blink code 83 Transport mode activated – Deactivate transport mode.
Blink code 85 Fault during charging – Disconnect the battery charger from the
vehicle and mains connection, wait 1
minute, restart the charging process.
– Replace the charging cable.
To Next Page