CHAPTER 4: Upgrading Your Computer
46
5 Unplug the cable from the back of the card reader, then
slide the card reader toward the front of your computer.
6 Slide the new card reader into place, then secure it with
the two screws you removed previously.
7 Plug the cable into the card reader.
8 Place the top bezel on top of the computer, then slide
bezel toward the back of the computer until it clicks into
place.
9 Reinstall the bezel by following the instructions in
“Replacing the front bezel” on page 37.
10 Reinstall the computer case’s side panel by following the
instructions in “Replacing the side panel” on page 38.
8512980.book Page 46 Thursday, March 6, 2008 1:30 PM
To Next Page
Loading...
Need help?
General
