EasyManuals Logo

Gateway e-4000 User Manual

Gateway e-4000
260 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #185 background imageLoading...
Page #185 background image
179
Gateway 4-bay Small Form Factor case
www.gateway.com
6 Install the new card into the add-in slot.
You can slightly seesaw the card end-to-end to help insert the card, but
do not bend the card sideways.
7 Push the add-in card retention cover inward. If you removed a screw,
replace it.
8 If you disconnected any cables, reconnect the add-in card cables using your
notes from Step 3. See the add-in card documentation for further
instructions.
9 Close the case by following the instructions in “Closing the case” on
page 161.
10 See the documentation that came with the card for any special software
installation instructions.
Replacing the power supply
To replace a power supply:
1 Identify your computer case style. For more information, see “Identifying
your computer case style” on page 106.
2 Open the case by following the instructions in “Opening the case” on
page 158.
3 Disconnect the power supply cables from all components (such as, hard
drives, CD/DVD/Recordable drives, and the system board), noting their
locations and orientation. (You will reconnect the cables after you install
the new power supply.)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Gateway e-4000 and is the answer not in the manual?

Gateway e-4000 Specifications

General IconGeneral
BrandGateway
Modele-4000
CategoryDesktop
LanguageEnglish

Related product manuals