CHAPTER 4: Advanced Hardware Setup
32
To configure your CrossFire video cards:
1 Click (Start), All Programs, ATI Catalyst Control
Center, then click ATI Catalyst Control Center. The
Control Center opens.
2 Change the settings you want, then click OK.
Connecting multiple displays to your CrossFire
video cards
When CrossFire is disabled and the interconnect cable is not
attached (when both cards are acting as standard video
cards), you can attach up to four displays to the video cards.
To use multiple displays on the CrossFire video cards:
1 Turn off your computer, then connect the displays to
the appropriate ports on your video cards.
2 Turn on your computer.
3 Click (Start), All Programs, ATI Catalyst Control
Center, then click ATI Catalyst Control Center. The
Control Center opens.
4 Click View to switch to Advanced View.
5 Click Disable CrossFire to disable Crossfire and enable
multiple monitor support, then click Apply. All display
devices are enabled.
6 On the tree menu to the left, click Displays Manager.
8511858.book Page 32 Monday, December 18, 2006 10:51 AM
To Next Page
Loading...
