www.gateway.com
49
4 If you are removing a DIMM from the memory module
bank, gently pull the plastic tabs away from the sides of
the memory module and remove it.
- OR -
If you are adding a DIMM to an empty memory module
bank, gently pull the plastic tabs away from the sides of
the memory module bank.
5 Align the notches on the new DIMM with the notches on
the memory module bank, then press the module firmly
into the bank. The tabs on the sides of the memory
module should snap into place to secure the memory
module.
6 Return your computer to its upright position.
7 Replace the side panel by following the instructions in
“Replacing the side panels” on page 48.
8 Reconnect the cables and the power cord.
9 Turn on your computer. Windows starts and the
Windows desktop appears.
10 Click (Start), right-click Computer, then click
Properties. The amount of memory in your computer
is displayed.
8513217.book Page 49 Wednesday, August 27, 2008 3:30 PM
To Next Page
Loading...
Need help?
General
