Magnapunch 2.0 – Installation and Operating Instructions
Page 6-2
Us e R in t e R f a C e
The LCD and the row of buttons below it make up
the user interface (UI). The LCD provides the current
status and settings of the Magnapunch 2.0, and
provides setup and operation instructions for using
your Magnapunch 2.0
naviGation
Use the buttons on the keypad to move between
menus, scroll, and make selections. The action of the
buttons is shown on the LCD.
When the Magnapunch 2.0 is turned on, the Start up
screen briefly displays, followed by the Home screen.
User Interface and Home screen.Figure 11.
HOME Returns to the Home screen.
UP Scrolls up through options.
When the selection gets to the top of
the options, it returns to the bottom
of the list.
BACK Goes back one screen.
DOWN Scrolls down through options. When
the selection gets to the bottom of
the options, it returns to the top of
the list.
NEXT Goes forward one screen.
SELECT Selects or commits menu selection.
MENU Displays an instructional menu.
When the Magnapunch 2.0 has been inactive for
more than 30 minutes, the LCD goes to the Start up
screen and “sleeps.” To “wake” up the LCD, press
any key.
LCD
Keypad
fi R s t ti M e se t U p
The first time the Magnapunch 2.0 starts up, you
need to set the language and unit of measure that
will be used on the menus. After the start-up screen
displays briefly, the Language Setup screen displays.
After you perform the setup, these screens do not
display. You can access them from the Home screen
any time by selecting MENU from the Home Screen
and then selecting SETUP feature from the MENU
options..
To set the language and units:
Turn On the Magnapunch 2.0.1.
Language Setup Screen.Figure 12.
On the Language Setup menu, press 2. UP or
DOWN to scroll to the desired language.
Press 3. SELECT to select the language.
Unit Selection ScreenFigure 13.
On the Unit Selection screen, press 4. UP or
DOWN to select CM or INCHES.
Press 5. SELECT.
Press 6. HOME to return to the Home screen.
To Next Page
Loading...
Need help?
General
