GBC Magnapunch 2.0 User Manual

Magnapunch 2.0 – Installation and Operating Instructions
Page 7-2
tR o U B l e s h o o t i n G
Symptom Possible Cause Corrective Action
Read error, punch is
operable
The barcode on the Die Set was not read
successfully.
Remove and reinsert the Die Set.
The bar code reader is malfunctioning Contact your service provider.
No Die Set loaded, punch
does not operate
Die Set is not fully inserted. Remove and re-insert the Die Set.
Die Set is not contacting the safety
switch.
Contact your service provider.
One or both Edge
Detection sensors remain
on.
Edge detection flag on Die Set is stuck in
an outward position.
Remove Die Set and push the edge
detection flag in. If problem continues,
replace the flag.
Sensor could be blocked by paper dust. Remove Die Set and blow air into the
area where the Die Set goes in the
Magnapunch 2.0.
No power. Power cord not fully inserted. Check the power cord to ensure it is
connected fully at both ends.
If this does not resolve the problem,
contact your service provider.
Faulty sensor. Contact your service provider.

GBC Magnapunch 2.0 Specifications

General

Brand	GBC
Model	Magnapunch 2.0
Category	Binding Machine
Language	English