GCC Technologies Expert 52 - Page 11

Expert 52 User Manual
Installation
2-4
Step 5
Insert the roll holder support with the screws into the holes of the stand, and then tighten them
up as shown in Figure 2-4 . You could decide roll holder support’s position by inserting into
different holes.
Step 6
Place two roll holders onto the roll holder support and ensure the white protrusion is wedged
in the groove. ( Figure 2-5 )
Roll holder support
3 screws
Figure 2-4
Roll holder support
Roll holder 1
Figure 2-5
Roll holder 2