Tip
For Vector Engraving jobs, we recommend a PPI setting > 150
For Vector Cutting jobs, we recommend a PPI setting of > 400
Raster / Vector (Pen Page) [DEFAULT SETTING: Selected]
Checking the Raster checkbox will process only the raster functions for the areas of your design that
correspond to that particular "pen" color. Checking the Vector checkbox will process the vector
functions for the areas of your design that correspond to that particular “pen” color.
As an example: a particular "pen" color may be assigned to areas in your design containing color lls
(raster engraving) and very thin lines (vector cutting). By checking / unchecking the Raster and Vector
will force the driver to process / ignore the color lls / thin lines.
Vector Checked Vector Unchecked
Raster Checked Processes both Vector and Raster
functions for that particular color
Processes only the Raster functions for
that particular color (Vector functions
ignored)
Raster Unchecked Processes only the Vector functions
for that particular color (Raster
functions ignored)
Does not process Vector or Raster
functions for that particular color
Auto Focus (Pen Page) [DEFAULT SETTING: Unselected]
This checkbox sets the Auto Focus for that particular job. With the Auto Focus button checked, the
LaserPro C180 will automatically initialize the auto focus procedure before starting the job. This will
ensure the focal distance is properly set based on the particular material you are working with and the
focal lens you have installed.
5.2.3.3 C180 Print Driver >> Advance Page
To Next Page
Loading...
