5.2 The LaserPro C180 Print Driver
With the LaserPro C180 print driver successfully installed, you will need to adjust the printer and page size
default settings before you can begin editing and completing jobs. By doing so, you will be setting the work
area in your graphics software to match the LaserPro C180’s worktable area.
NOTE
Please make sure the LaserPro C180 is set to the default printer before proceeding to
the page and layout setup.
Ensure that the LaserPro C180 has been selected as the DEFAULT PRINTER. You can do so by going into
your Windows Control Panel
→
Printers and Faxes.
If LaserPro C180 is not selected as DEFAULT PRINTER, you may set it up through the graphics software as
well. The following is taking Corel Draw as example of how to set up LaserPro C180 as the Printer.
1) From the primary menu, click FILE
→
PRINT SETUP.
2) From the navigation bar Name, click C180
→
OK
5.2.1 Page Setup and Orientation
The rst thing you must do before working with the LaserPro C180 Print Driver will be to make sure the
page and layout settings are properly congured within your graphics software. You will need to access
and edit the Page Setup or Layout page of your graphics software to set your graphics software’s page
layout to match the LaserPro C180’s work table’s dimensions and orientation.
From your graphic software’s Page Setup page:
• Set the page orientation in the graphics software to Landscape mode.
• Set page size horizontal length to 458 mm (18 inches) and vertical height to 309 mm (12 inches).
To Next Page
Loading...
