5.2.3.7 C180 Print Driver >> Stamp Page
Producing stamps require different operational steps than your standard engraving or cutting jobs. The
Stamp page offers dynamic options allowing you to customize your stamp production process.
NOTE
The Stamp page will only appear and be accessible when you have selected the Stamp
Mode from the Option Page.
Tip
Functions located on the other pages that are useful when making a stamp:
Set Shoulder, Pitch, Border, Invert, and Mirror.
Pitch (Stamp Page)
Your stamp will be a reversed image composed of engraved depressions and ridges. Think of these
ridges as the "contact sections" of the stamp. If the ridges of these contact sections are too thin, they
may break. The Pitch setting allows you to increase the width of the ridge base, hence creating more
stable "contact sections" and longer lasting stamp. The pitch value setting allows you to adjust the
base width of the ridge. Broad pitch gives the maximum amount of support for each ridge. Experiment
with different pitch value settings in order to produce the stamp that is best suited for your application.
To Next Page
Loading...
