68K System Monitor
User's Guide
GE Energy Services
General SWM0023-1.00 -2
Full Release
3-7
BOOT - Startup
-
Platform
þ
CPM
þ
D20
D20 Base
þ
D20 ME
D20 Base
þ
D20/200
CCU Base
þ
D20/200 ME
CCU Base
þ
D25
Description
Use this command to remove all defined Monitor breakpoints and then force the
system to go through its lowest level start-up.
This ensures that the system is properly re-initialized after testing, system
manipulating, or downloading.
Syntax
Below is usage and syntax information for this command
Command Format
CPM / D20 / D20ME / CCU/ CCUME boot
D25 boot [/i] [delay]
Variables
delay = number of milliseconds to wait before the boot is
performed
Parameters
/i = skip all additional system processing and reset
the system immediately
Example
Type boot and press ENTER.
Results: The system responds with the normal boot-up screen.
It displays a series of messages relating to hardware
and software initialization.
Special
Considerations
This command will automatically clear all breakpoints before
execution.
This command causes all processors in a multi-processor
system to reboot.
To Next Page
Loading...
