GE 68K System - PRG - Program Flash

68K System Monitor
User's Guide
GE Energy Services
General SWM0023-1.00 -2
Full Release
3-49
PRG - Program Flash
Platform
o
CPM
o
D20
D20 Base
o
D20 ME
D20 Base
o
D20/200
CCU Base
þ
D20/200 ME
CCU Base
o
D25
Description
Use this command to program a FLASH memory.
Syntax
Below is usage and syntax information for this command
Command Format
prg [/(b | w | l)] address data
Variables
/b = bytes (octets), the default mode
/w = words
/l = long words
Parameters
address = address at which to store the data, in hexadecimal
data = the data to store
Example
Not Required
Special
Considerations
Use with great care. Command will change contents of Flash
memory without updating checksum.