68K System Monitor
User's Guide
GE Energy Services
General SWM0023-1.00 -2
Full Release
3-33
EL - Error Log
Platform
þ
CPM
þ
D20
D20 Base
þ
D20 ME
D20 Base
þ
D20/200
CCU Base
þ
D20/200 ME
CCU Base
þ
D25
Description
Use this command to display and delete system error log entries stored in NVRAM
for a single or multi-processor system.
The display command also presents the current system state, and any significant low-
level system errors which occur.
The delete function deletes system error log entries from memory, and clears the
disabled state if the system is in a disabled state.
Syntax
Below is usage and syntax information for this command
Command Format
CPM / D20 el / (p | r)
D20ME / CCU / D25 el / (p | r | f)
Variables
/p = print the error log entries
/r = reset (delete) the error log entries
/f = fix an error log that contains an infinite loop
Parameters
None
Example
Type el /p and press ENTER.
Results: This command displays the error log entries
maintained by the system and the system state.
The system returns the prompt when it completes this
instruction
Special
Considerations
None
To Next Page
Loading...
