GE ApexPro

3-2 ApexPro™ 2001989-200E
Equipment setup
Transmitter setup
Views
The transmitters have the following buttons and LEDs:
605A, 205A
ApexPro Transmitter and ApexPro CH Transmitter
ApexPro ApexPro CH Function
RL RA LA LL Va Vb RL RA LA LL Va Vb
N R L F Ca Cb
When first powered up, the lead LEDs flash
rapidly, followed by two slow flashes. The
transmitter begins functioning after the two
slow flashes.
When any of the transmitter's buttons are
pushed, the lead LEDs flash twice.
Change Battery When the battery power is running low, the
change battery LED flashes.
Verify Leads
When pressed, the lead LEDs flash twice. If a
lead is valid, its LED stays lit for one minute.
Pause Alarm
When the Pause Alarm condition occurs, the
pause alarm LED flashes until the condition
ends. See Pausing alarms at the transmitter
on page 5-5.