Equipment setup
2001989-200E ApexPro™ 3-7
Antenna system
Patient and transmitter status data are dependent on the telemetry system transmission
coverage area. For more information on the telemetry coverage area in your
institution, contact your biomedical or information technology engineers.
417A
Optional components
WARNING
LOSS OF ALARMS—Do not use transmitter accessory devices
such as SpO2 and NBP without ECG cables attached. Failure to use
accessory devices in the prescribed manner may result in a loss of
alarms.
ECG cables must be attached to the transmitter while using any accessory device such
as oximeter, Dinamap Pro monitors, etc.
Xpod oximeter
CAUTION
Use only Nonin SpO2 probes with the oximeter. The reliability of
SpO2 data obtained with any other probe has not been verified.
The Xpod oximeter uses the battery power supplied by the transmitter. Connect the
oximeter to the INTFC connector (labeled 2 on its dust cover) on the transmitter and
to the Nonin SpO2 probe. Once connected, follow your unit’s protocol for attaching
the transmitter and the oximeter to the patient.
428A
To Next Page
Loading...
