Alarms
2001989-200E ApexPro™ 5-13
319E
Parameter limits
1. To change the unit defaults for Parameter Limits and Alarm Levels, use the
mouse to click in the Low or High field for the parameter you wish to edit. The
field is framed by a rectangle, and up and down arrow buttons appear in the field.
329A
2. To increase or decrease the limit by 5, click on the up or down arrow button.
To increase or decrease the limit in increments other than 5, use the keyboard to
enter a new limit value.
3. Once you have set the desired limit, click on the Apply button for the changes to
take effect.
NOTE
If you make only one change, you do not need to click on the Apply button.
The change will take effect automatically, and the Apply button will appear
dimmed.
4. If you are finished making changes to the Telemetry Alarm Control Defaults tab
sheet, click the OK button.
To Next Page
Loading...
