GE ApexPro

Equipment setup
2001989-200E ApexPro™ 3-13
securely tightened. Then plug the 3-pin microphone connector into the 3-pin
connector on the microphone cable.
404A
5. Connect the 5-pin end of the interface cable to the inside 5-pin INTFC connector
on the transmitter (labeled 1 on its dust cover). The interface cable is already
connected to the blood pressure monitor because it is a branch of the patient
cable. Ensure that the transmitter’s patient leadwires are properly connected. The
leadwires must be connected for telemetry transmission of NBP data.
NOTE
 Use a microphone pad to maintain the best microphone position.
 Use a cuff anchor to maintain the blood pressure cuff’s position.
 Advise the patient not to shower or bathe while being monitored.