Programming Site Data 2-1
September 2004
Introduction The AT868 has a user program that provides access to the various
programmable features of the unit. To program the AT868 you can
use either the internal keypad or Panaview™, which is a PC-based,
non-resident software program that communicates with the AT868
through its serial port.
Note: Only the internal keypad programming methods are described
in this manual. See the PanaView manual for instructions on
using that software.
To begin taking measurements with the AT868, you must at least:
• activate the channels
• enter the channel data
• enter the global system data
• enter the pipe parameters
As a programming aid, a complete set of menu maps are included in
Appendix A, Menu Maps. The specific figure numbers are referenced
throughout this chapter.
Note: Only the programming required for initial setup is described
in this manual, but the menu maps show all available
programming features for the AT868.
Activating a Channel
[CHx-ACTIV Menu]
The CHx-ACTIV submenu (see Figure A-1 on page A-1) is used to
activate or deactivate the channels. All installed channels should be
activated when you receive your unit. However, you should verify
that the channels are active before you begin programming.
Note: In this manual, only the programming of Channel 1 is
described. To program Channel 2 of a 2-channel meter, simply
repeat the same procedures described for Channel 1.
To Next Page
Loading...
