September 2004
2-6 Programming Site Data
Pipe Material If a standard or special clamp-on transducer is being used, the
programming sequence should be rejoined here.
1. Press [
W] and [X] to select the pipe material and press [ENTER].
Some of the pipe materials require additional selections. See a
complete list of choices in Table 2-1 below.
Table 2-1: Pipe Material Choices
Material Types
STEEL Carbon Steel
Stainless Steel
IRON Ductile
Cast
Cu (Copper) no additional selection required
Al (Aluminum) no additional selection required
BRASS no additional selection required
CuNi
(Copper Nickel)
70% Cu 30% Ni
90% Cu 10% Ni
GLASS Pyrex
Heavy silicate flint
Light borate crown
Plastic Nylon
Polyethylene
Polypropylene
PVC, CPVC
Acrylic
OTHER Enter the sound speed of the pipe material by
using the arrow keys. Press [
W] and [X] to
move the cursor to desired location and press
[S] and [T] to increase or decrease the
number and press
[ENTER].
To Next Page
Loading...
