GE Bently Nevada 3300/25 - 17. Error Codes

3300/25 Dual Accelerometer Input Monitor Operation Manual
46
17. Error Codes
Refer to the Monitor Functions, Section 2 and Self Test, Section 16 for more information
about displaying error codes. Refer to the Self Test section for information about clearing
stored errors.
ERROR
CODE
DESCRIPTION EXPLANATION/RECOVERY
2 ROM checksum failed. Tested at power up and User-invoked self
test. This error is displayed on the front
panel, but is not stored in memory. Install
your spare monitor or contact your local
Bently Nevada office for service.
3 Nonrecoverable EEPROM failure. Tested only at Cyclic self test. Install your
spare monitor or contact your local Bently
Nevada office for service.
4 EEPROM failure. May be corrected by adjusting alarm
setpoints in the monitor (See section 10).
If setpoint adjustment fails to correct this
error, install your spare monitor or
contact your local Bently Nevada office
for service.
5 +7.5V/-VT node out of tolerance.
6 +VRH node out of tolerance.
7 +5V node out of tolerance.
8 MVREF node out of tolerance.
9 +7.5V node out of tolerance.
10 +VRL node out of tolerance.
11 MVREF/-6.5V node out of
tolerance.
12 +5V/-7.5V node out of tolerance.
13 Clock OK voltage out of
tolerance.
Tested cyclically. If it is a stored error,
recall and clear the error codes as
described in the Self Test, Section 16.
If it is an active error, replace the monitor
with a spare or contact your local Bently
Nevada office for service.
14 RAM failure.
17 COP watchdog not configured.
Tested only at Power-up or User-invoked
self test. These errors are displayed on
the front panel but not stored in memory.
Install your spare monitor or contact your
local Bently Nevada office for service.
NOTE: If the monitor experiences recurring stored errors contact your local Bently
Nevada office for service.