GE C30 User Manual

5-36 C30 Controller System GE Multilin
5.2 PRODUCT SETUP 5 SETTINGS
5
PATH: SETTINGS  PRODUCT SETUP  COMMUNICATIONS  DNP / IEC104 POINT LISTS  ANALOG INPUT / MME POINTS
Up to 256 analog input points can be configured for the DNP or IEC 60870-5-104 protocols. The analog point list is config-
ured by assigning an appropriate FlexAnalog parameter to each point. Refer to Appendix A: FlexAnalog Parameters for the
full range of assignable parameters.
The DNP / IEC 60870-5-104 point lists always begin with point 0 and end at the first “Off” value. Since DNP / IEC
60870-5-104 point lists must be in one continuous block, any points assigned after the first “Off” point are ignored.
Changes to the DNP / IEC 60870-5-104 point lists will not take effect until the C30 is restarted.
k) IEC 61850 PROTOCOL
PATH: SETTINGS  PRODUCT SETUP  COMMUNICATIONS  IEC 61850 PROTOCOL
The C30 Controller System is provided with optional IEC 61850 communications capability. This feature is
specified as a software option at the time of ordering. Refer to the Ordering section of chapter 2 for addi-
tional details.
 ANALOG INPUT / MME
 POINTS
Point: 0
Off
Range: any FlexAnalog parameter
MESSAGE
Point: 1
Off
Range: any FlexAnalog parameter
↓
MESSAGE
Point: 255
Off
Range: any FlexAnalog parameter
 IEC 61850 PROTOCOL

 GSSE / GOOSE
 CONFIGURATION
MESSAGE
 SERVER
 CONFIGURATION
MESSAGE
 IEC 61850 LOGICAL
 NODE NAME PREFIXES
MESSAGE
 MMXU DEADBANDS

MESSAGE
 GGIO1 STATUS
 CONFIGURATION
MESSAGE
 GGIO2 CONTROL
 CONFIGURATION
MESSAGE
 GGIO4 ANALOG
 CONFIGURATION
MESSAGE
 GGIO5 UINTEGER
 CONFIGURATION
MESSAGE
 REPORT CONTROL
 CONFIGURATION
MESSAGE
 XCBR
 CONFIGURATION
MESSAGE
 XSWI
 CONFIGURATION
NOTE
NOTE

GE C30 Specifications

General

Brand	GE
Model	C30
Category	Controller
Language	English