GE Concord 4 Installation Manual

Chapter 3: Programming
46 Concord 4 Installation Manual
5. Press # and the display stops flashing.
To disable keyfob PTN:
1. Enter this menu (display showing KEYCHAIN TP PTN), then press #.
The display shows the lowest touchpad sensor number assignment such
as: S1 P1 G0 TP RF where S1 is sensor 1, P1 is partition 1, G0 is
sensor group 0, TP is touchpad and RF is wireless.
2. Press # to accept this keyfob or press A or B until the desired keyfob
appears, then press #. The display shows ARM PARTITION.
3. Enter the partition numbers that are displayed (except for the partition
you assigned the touchpad when it was learned). Each disappears from
the display with the touchpad’s original partition number left flashing.
4. Press # and the display stops flashing.

GE Concord 4 Specifications

General

Zones	96
Partitions	6
User Codes	230
Power Supply	16.5 VAC, 40 VA
Wireless Compatibility	Compatible with GE wireless sensors
Keypads	Up to 8
Outputs	2 onboard, expandable
Event Log	512 events
Backup Battery	12VDC, 7AH
Communication	Phone line, optional cellular or IP