GE Concord 4

Chapter 3: Programming
86 Concord 4 Installation Manual
Attach schedules to events menu
This section describes how to link the system events to time schedules.
Latchkey reports
Shortcut:
060nn (opening),
061nn (closing), where
nn is schedule number
Default: Off
This setting lets you attach the latchkey opening report feature and the
latchkey closing report feature to time schedules.
To attach a schedule to latchkey opening or latchkey closing:
1. Press A or B until the display shows ATTACH SCHEDULES TO EVENTS.
2. Press # then A or B until the display shows LATCHKEY OPENING or
LATCHKEY CLOSING.
3. Press # and the display shows SCHEDULE 00 OFF/ON (current
setting). If you want a different schedule, press A or B until the desired
schedule appears.
4. Press 1 (off) or 2 (on). The display flashes the entered selection. Press #
and the display shows the new setting for the selected schedule.
Exception reports
Shortcut:
062nn (opening),
063nn (closing), where
nn is schedule number
Default: Off
This setting lets you attach the exception opening report feature and the
exception closing report feature to time schedules.
To attach a schedule to exception opening or exception closing:
1. Press A or B until the display shows ATTACH SCHEDULES TO EVENTS.
2. Press # then A or B until the display shows EXCEPTION OPENING OR
EXCEPTION CLOSING.
3. Press # and the display shows SCHEDULE 00 OFF/ON (current
setting). If you want a different schedule, press A or B until the schedule
appears.
4. Press 1 (off) or 2 (on). The display flashes the entered selection. Press #
and the display shows the new setting for the selected schedule.
Lights
Shortcut: 064xnn where
nn is schedule number
and x is light number
minus 1
Default: Off
This setting lets you attach light controls to a time schedule.
To attach schedules to lights:
1. Press A or B until the display shows ATTACH SCHEDULES TO EVENTS.
2. Press # then A or B until the display shows LIGHTS. Press # to enter the
Lights menu.
3. Press A or B until the light appears.
4. Press # and the display shows SCHEDULE 00 OFF/ON (current
setting). If you want a different schedule, press A or B until the desired
schedule appears.
5. Press 1 (off) or 2 (on). The display flashes the entered selection. Press #
and the display shows the new setting for the selected schedule.
6. Repeat the process until all desired lights are attached to schedules.