Chapter 3: Programming
Concord 4 Installation Manual 85
Set up schedules menu
The set up schedules menu lets you set up timeframes for light control, output
control, automatic arming, latchkey times, and exception opening/closing reports.
The system (all partitions) allows you to set up to 16 schedules (00 to 15) that are
shared by all partitions.
Setting up schedules consists of setting a start and stop time for each schedule, then
selecting which days of the week the schedule will be active. You can also set up a
rollover schedule, which starts on one day and ends on another day. This saves
programming time and leaves more schedules available (in case they are needed
later).
For example, to set up a schedule to rollover from Tuesday evening to Wednesday
morning, set a schedule start time for 2200 (10:00 p.m.) and a stop time for 0500 (5:00
a.m.). Set the schedule to turn on Tuesday. Because the stop time is set for morning,
the system automatically carries the schedule over to the next day.
If you use the same start and stop times described above and set the schedule to
turn on Monday through Friday, then one schedule will cover the entire week.
Set up schedules
Shortcut: 05XXY,
where XX is schedule 00
to 15 and Y is start
(0)/stop (1) Monday to
Sunday (2 to 8)
Default: 00:00
This menu lets you set up start/stop times for each day of the week.
Schedules used by one partition cannot be viewed or changed from a
different partition.
If you are programming schedules for your customer, be sure to record the
settings in the Concord 4 User Manual.
To set up a time schedule:
1. Press A or B until the display shows SET UP SCHEDULES.
2. Press # and the display shows SCHEDULE 00. If you want a different
schedule number, press A or B until the schedule number appears.
3. Press # and the display shows START TIME hh:mm (current setting).
4. Enter the starting time (00:00 to 23:59). The display flashes the entered
time. Press # and the display shows START TIME hh:mm (new setting).
5. Press B and the display shows STOP TIME hh:mm (current setting).
6. Enter the desired stop time (00:00 to 23:59). The display flashes the
entered time. Press # and the display shows STOP TIME hh:mm (new
setting).
7. Press B and the display shows MONDAY OFF/ON (current setting). To
select a different day, continue pressing B until the desired day appears.
8. Press 1 (off) or 2 (on). The display flashes the entered selection. Press #
and the display shows the new setting for the selected day.
9. Repeat the process until all desired settings for each day are set.
To Next Page
Loading...
Need help?
General
