DigitalFlow™ XGM868i Startup Guide 33
Chapter 2. Initial Setup
2.4.1a Selecting Volumetric Units
1. Scroll to the desired Volumetric Units for the flow rate display and press [Enter]. Table 6 lists the available
volumetric units.
2. Scroll to the desired unit of Volumetric Time (from seconds to days), and press [Enter].
3. Scroll to the desired number of Vol Decimal Digits (digits to the right of the decimal point) in the volumetric flow
display, and press [Enter].
2.4.1b Selecting Totalizer Units
4. Scroll to the desired Totalizer Units for the flow rate display and press [Enter]. Available units are listed in Table 6.
5. Scroll to the desired number of Tot Decimal Digits (digits to the right of the decimal point in the totalized flow rate
display) and press [Enter].
6. Do one of the following:
• If MASS FLOW is ON, proceed to Selecting Mass Flow Units on page 34.
• If MASS FLOW is OFF, the meter returns to the Global PROGRAM window. Press [Escape] twice and proceed to
Chapter 3, Operation, or the Programming Manual.
Note: To activate mass flow, see Activating Mass Flow in Chapter 1 of the Programming Manual. The following
prompts appear only if mass flow is activated for both channels.
Table 6: Available Volumetric/Totalizer Units
English Metric
ACF = Actual Cubic Feet ACM = Actual Cubic Meters
KACF = Thousands of ACF KACM = Thousands of ACM
MMACF = Millions of ACF MMACM = Millions of ACM
SCF = Standard Cubic Feet SCM = Standard Cubic Meters
KSCF = Thousands of SCF KSCM = Thousands of SCM
MMSCF = Millions of SCF MMSCM = Millions of SCM
To Next Page
Loading...
