17 Druck ADTS 2XX User Manual
K0451 Issue No. 1
Ground
Selected in Control Mode
1. Use the GROUND touch screen key to select go-to-ground. The displayed channel aims show
GROUND, the controller takes all channels to ground pressures and Qc to zero as shown above.
Note:
At any time during this operation, pressing Leak/Measure stops the operation.
2. The display shows At Ground Pressures (see above). Pressing “OK” cancels the yellow message box
but leaves the system “At Ground”. Pressing Leak/Measure returns the system to Leak/Measure
mode.
To Next Page
Loading...
