Druck ADTS 2XX User Manual 24
K0451 Issue No. 1
Transferring <NEW AIRCRAFT.CSV> files from a PC to:
the ADTS 2XX Advanced Hand Terminal or ADTS 2XX
New .csv file test scripts can be tested for general syntax and screen formatting using the desktop PC utility
“ADTS 2XX Remote” (DK250). This utility requires no external equipment connections to operate, available for
installation from the distributor.
Transferring Files using GE FileTransfer Utility
CAUTION:DO NOT CONNECT THE POWER PACK (Table 2-1, item 6) TO THE PC COMMUNICATIONS CABLE (Table 2-1, item
5)
WHEN IT IS CONNECTED BETWEEN THE ADTS 2XX AND PC.
Connect the PC communications cable (Table 2-1, item 5)
into an available 9-way ‘D‘ COM port on the PC and the
connector of the Advanced Hand Terminal.
Use the icon on the windows CE desk top to start the File
Transfer Utility.
To start the File Transfer Utility on the PC, double click the
icon, set the File Transfer Utility, click the to
expand the Advanced Hand Terminal drive as shown:
Notes:
1. Check which serial communications has been connected,
use the RS232 drop-down menu to set the PC
communications port (COM1 to COM 4). The system stores
this setting and automatically selects this port on the next
power-up.
2. Only files directly loaded to the AHT will be accessible in the
AHT menus. To be accessible from the ADTS 2XX the files
must be also loaded in the ADTS 2XX. This requires a
different connection configuration see Figure 2-4.
To Next Page
Loading...
