4-46 F650 Digital Bay Controller GEK-106310AB
4.2 HUMAN MACHINE INTERFACE (HMI) 4 HUMAN INTERFACES. SETTINGS & ACTUAL VALUES
4
4.2.5.6 VIEW SETTINGS
To enter this menu press the enter/shuttle key when the option "View Settings" is selected in main menu (). A secondary
level will be displayed with different sublevels as shown on Table 4.30:. Pressing up-down keys or rotating the shuttle key,
(left for moving up and right for moving down) select the next level to be displayed (), press the enter/shuttle key again to
enter in next level and press esc key to return to previous level if desired. This navigation will be performed the same for all
the menus in "View Settings". Once the last sublevel is reached, move up and down to visualize the settings selected.
Table 4.30: GENERAL OVERVIEW OF "VIEW/CHANGE SETTINGS" MAIN MENU
MAIN SETTINGS MENU FIRST LEVEL SECOND LEVEL THIRD LEVEL
Product Setup >
Communication >
Serial Ports
Ethernet >
Ethernet 1
Ethernet 2
ModBus Protocol
DNP3 Slave (Available for
standard and IEC61850
models)>
DNP3 Slave 1
DNP3 Slave 2
DNP3 Slave 3
IEC 870-5-104(Available for
standard and IEC61850
models)>
SNTP
PROCOME (Available for
procome models only).
Fault Report
Oscillography
Demand
Time Settings
System Setup >
General Settings
Breaker >
Breaker Settings
Breaker Maintenance
Protection Element >
Phase Current >
Phase TOC High >
Phase TOC High 1
Phase TOC High 2
Phase TOC High 3
Phase TOC Low >
Phase TOC Low 1
Phase TOC Low 2
Phase TOC Low 3
Phase IOC High >
Phase IOC High 1
Phase IOC High 2
Phase IOC High 3
Phase IOC Low >
Phase IOC Low 1
Phase IOC Low 2
Phase IOC Low 3
To Next Page
Loading...
