5-164 F650 Digital Bay Controller GEK-106310AB
5.11 IEC 61850 CONFIGURATION 5 SETTINGS
5
5.11IEC 61850 CONFIGURATION
The 61850 Configuration option will only be available if the F650 supports this protocol (6 in the ordering code for protocol
selection) with firmware versions 3.44 or lower. For firmware versions 3.60 or higher ones, please go to section 7.3 IEC
61850 CONFIGURATOR.
This menu is located in Setpoint > 61850 Configuration
The user can configure some 61850 parameter in the F650.icd file and then send this file to the relay. The parameters that
are possible to configure are:
Domain name parameters:
• IED Name
• LD Name from the Domain Name
Ethernet parameters:
• IP Address
• Subnet Mask
• Gateway
Figure 5–60: IED NAME AND ETHERNET PARAMETERS CONFIGURATION
To Next Page
Loading...
