GEK-106310AB F650 Digital Bay Controller 7-5
7 IEC 61850 PROTOCOL 7.1 IEC61850 GENERIC SUBSTATION STATE EVENT (GSSE)
7
7.1.3.2 USERST BIT PAIRS
Remote Outputs 1 to 64 originate as GSSE messages to be transmitted to remote devices. Each digital point in the
message must be programmed to carry the state of a specific PLC operand. The setting above is used to select the
operand which represents a specific UserSt function to be transmitted. They are displayed in EnerVista 650 Setup:
Actual Values > Input/Outputs > Remote Outputs > User St
Each User Set point can be ONLY programmed and displayed in EnerVista 650 Setup (see Figure 3):
Setpoint > Relay Configuration > Remote Outputs
Actual > Inputs/Outputs > Remote Outputs > User St
Figure 7–3: REMOTE OUTPUTS > USER SET
To Next Page
Loading...
