9-12 F650 Digital Bay Controller GEK-106310AB
9.2 BOOTWARE UPGRADE 9 BOOTCODE AND FIRMWARE UPGRADE
9
Figure 9–17: UPDATE CONFIRM
14. If click “YES” ("Sí" in the figure) the process will start, beginning with the relay flash memory deletion, so at this point
all the information stored in the relay will be lost. Until now, no important change has been made to the relay, the boot
memory upgrading process has just been prepared.
The process of flash memory erasing and boot code downloading can take some minutes, during which a progress bar
is displayed.
Figure 9–18: FLASH MEMORY ERASE PROGRESS BAR
15. If the process is successful, continue with step 16 hereafter. If not and the relay gets stuck during at "Sending file
imagen_kernel…" (Figure 9–20:)
Figure 9–19: DOWNLOAD PROCESS ADVISORY
To Next Page
Loading...
