GEK-106310AB F650 Digital Bay Controller 9-23
9 BOOTCODE AND FIRMWARE UPGRADE 9.3 FIRMWARE VERSION UPGRADE
9
12. Click Ok (Aceptar). At this point, the firmware upgrade procedure is finished and the relay is ready to be powered OFF
and ON to check that the firmware has been upgraded properly.
13. User settings and logic files downloading
When upgrading the firmware the entire settings and relay configuration are reset to factory default values. Then
the User is committed to download the settings, configuration and logic files to the relay in order to get it fully
operative.
Calibration settings and configuration must be loaded to the relay the relay was bootware upgraded also. If not calibration
files were maintained during the firmware upgrading process.
To recover and download the different files to the relay go to Enervista 650 Setup and at the top menu bar choose:
• COMMUNCATION>CALIBRATION>SET CALIBRATION FILES: to restore in the relay the calibration settings if
necessary.
• FILE>CONFIG FILE (*.650) Converter: to convert the setting and configuration file *.650 for the relay (if it was in a
previous version format).
• FILE>SEND INFO TO RELAY: to send the new settings and configuration file to the unit.
To Next Page
Loading...
