GEK-106310AB F650 Digital Bay Controller 4-21
4 HUMAN INTERFACES. SETTINGS & ACTUAL VALUES 4.1 ENERVISTA 650 SETUP SOFTWARE INTERFACE
4
Control Events
Up to 128 user programmable events from any logical variable, contact
or virtual input. Possibility to display the event as an alarm on the alarms
panel. Control events are also displayed in the snapshot events
recording. 1 ms time tagging.
A control event is a logic signal associated to an operand or combination
of operands, that allows following the status of that signal.
Switchgear
Up to 16 configurable switchgear elements. A switchgear element can be
a breaker, a line selector switch, a grounding selector switch, a busbar
selector switch, etc. This screen allows configuration of type of contacts,
opening and closing time, contact assignation and text for events related
to switchgear. There are 64 pre-established events for switchgear, which
correspond to opening, closing, Error01 and Error11 of the 16
programmable switchgear elements.
Remote outputs
Up to 32 DNA bits and 64 user St bits to be transmitted to remote devices
over CAN using GSSE messages
Inputs
Text configuration for off-line mode file management for all the contact
inputs available in device.
Virtual Inputs
Text configuration for off-line mode file management. 32 latched and 32
self reset virtual inputs.
MMI (HMI-Human
Machine Interface)
Screen one line diagram configuration. This menu shows a scenario to
draw a simplified one-line diagram of a bay in a feeder, line, transformer,
etc. The menu includes a library for power elements, metering elements,
text and drawings. See an example on the next page.
To Next Page
Loading...
