GE FP1/4200 - Blade, Disc, and Cover Installation

2. Knife Blade ~
* Grasp Knife Blade by center hub (H). With blade-side down line up flat
side of center hub with flat side of Center Post and lower Knife Blade to
bottom of Bowl.
m
3. Reversible Disc § '1
CENTER HUB
WITH OPENING
a
* Th is Disc will slice or shred depending on which side is facing up.
* Grasp Reversible Disc by center hub (I) and turn so desired side (eith er
slicing or shredding) is facing upward.
* Position opening in center hub of Reversible Disc over Center Post of
Bowl (1). (Note that flat side of center hub on side of Disc facing up ward is
always opposi te flat side of Center Post.)
* Rotate Disc until it slides down Center Post into place- abo ut 1 inch
dow n.
NOTE: Remember to remove Knife Blade before using Reversible Disc,
unless
both attachments are to be used together.
4. Food Processor Cover
For your protection, this appliance has a cover i nterlock system The
cover must be
correctly in place before the Food Processor will
operate. DO NOT ATTEMPT TO OPERATE WITHOUT THE FOOD
PROCESSOR COVER CORRECTLY
IN PLACE.
9