GE Giraffe Blue Spot PT Lite - Page 70

6. Use a 5.5mm nut driver to remove the nut that attached the LED Ground Harness to the back plate to
release the harness (Refer to Figure 11-10 ).
7. Use a 7mm nut driver to remove the nuts that attach the LED module to the back plate and pull out the
whole module and fan assembly (Refer to Figure 11-13).
NOTE: Skip step 8 if the LED module FRU kit is ordered for replacement. The kit contains the LED module
with a new fan attached to it.
8. To remove the fan, use a Philips screwdriver to remove the fan screws to release the fan (Refer to Figure
11-14 ).
9. Reverse the steps to re-install.
NOTE: When re-installing the fan, make sure that the arrow symbol on the top side of the fan points
towards the heat sink to avoid backward installation (Refer to Figure 11-15 ). Furthermore, to re-install
the bae, position it such that the bae holes are on the left side (Refer to Figure 11-16 ).
Figure 11-13
Figure 11-14
Figure 11-15 Figure 11-16
70
Chapter 11: Replacement Procedures