D
IRECTION 5813707-100, REVISION 2 VENUE™ SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-7
PRELIMINARY
• Tighten the 6 remaining upper screws
NOTE: Make sure the eDP cable connector is not pinched when closing the back cover.
2.) Install Probe Holder Rubber on the top of the system.
3.) Install the batteries.
Note: IMPORTANT: Remove all labels from the old back cover and adhere them on the back side of
the newly installed back cover.
Figure 8-76 Fastening 10 captive Screws: Order
Figure 8-77 eDP connector
To Next Page
Loading...
