D
IRECTION 5813707-100, REVISION 2 VENUE™ SERVICE MANUAL
8-24 Chapter 8 - Replacement Procedures
PRELIMINARY
8-2-8-5 C-BEB Installation Procedure
1.) Install SSD.
2.) Install the C-BEB.
3.) Reconnect the eDP cable.
4.) Insert the protruding eDP cable part into the designated groove to avoid cable pinching while
closing the back cover.
5.) Reconnect the Wifi module.
6.) Install the Wi-Fi antenna securing bracket and tighten the bracket holding screw.
7.) Secure the 5 screws (long screws are used for the heat sync).
8.) Connect the speakers cable.
9.) Install the fan.
10) Install C-PSB.
11.)Install back cover.
Figure 8-102 Insert the Protruding Part into the designated groove
• Fan Installation Procedure
• C-PSB Installation Procedure
• Back Cover Installation Procedure
To Next Page
Loading...
