D
IRECTION 5813707-100, REVISION 2 VENUE GO™ SERVICE MANUAL
Chapter 1 - Introduction 1-11
PRELIMINARY
BEWARE OF POSSIBLE SHARP EDGES ON ALL MECHANICAL PARTS. IF SHARP
EDGES ARE ENCOUNTERED, THE APPROPRIATE PPE SHOULD BE USED TO
REDUCE THE RISK OF INJURY.
WEAR ALL PPE INCLUDING GLOVES AS INDICATED IN THE CHEMICAL MSDS.
USE PROTECTIVE GLASSES DURING DRILLING, FILING AND DURING ALL OTHER WORK
WHERE EYES NEED PROTECTION.
USE SAFETY SHOES WHEN DOING WORK WHERE THERE IS ANY CHANCE OF FOOT
DAMAGE.
USE PROTECTIVE GLOVES WHEN DRILLING AND CUTTING.
To Next Page
Loading...
