GE HEALTHCARE
DIRECTION 5162630, REVISION 3 LOGIQ™ S6 SERVICE MANUAL
Section 8-3 - Software Loading Procedures (R7.7.x or later with BEP4) 8-47
6.) In Utility> System> General, set the Language as JPN. Save this setting, but do not reboot the
system yet.
8-3-10-6 Regional Setup (For the system with language other than English ONLY) (cont’d)
Figure 8-166 Regional and Language Options
Figure 8-167 JPN as Language
Check
Do not
Change
English.
To Next Page
Loading...
