GE HEALTHCARE
DIRECTION 5162630, REVISION 3 LOGIQ™ S6 SERVICE MANUAL
Section 8-3 - Software Loading Procedures (R7.7.x or later with BEP4) 8-49
8-3-10-6 Regional Setup (For the system with language other than English ONLY) (cont’d)
9.) Select the Advanced tab, then select Japanese in the Language for non-Unicode programs pull-
down menu. Press Apply. Answer Yes to use files already loaded on the hard disk, then answer
No to not reboot the system yet, press OK. Press Save and Exit the Utility screen.
10.)Reboot the system.
11.)In Utility--> System--> General, press Regional Options. Select Language Tab and press
Details. Remove English under Installed Services and press Apply and OK.
12.)Select Utility--> System--> About-->Additional Info menu.
13.)Select Automatic Setup for Japanese Language button. Then IME configuration shall be
automatically done.
This configuration shall setup the keyboard assignment (remove 半角かな , etc) in IME.
14.)Reboot the system.
NOTICE
To have the settings take effect, you MUST turn off the system and turn it back on.
Figure 8-170 Automatic Setup for Japanese Language
To Next Page
Loading...
