GE MOTOR MANAGER 2 User Manual

4-2 MM2 Motor Manager 2
GE Power Management
4.1 OVERVIEW 4 SETPOINTS
4
• GND: Ground
•Hz: Hertz
• KOHMS: kiloOhms
• MAX: Maximum
• MIN: Minimum
• SEC, s: Seconds
• UV: Undervoltage
• VT: Voltage Transformer
Figure 4–1: SETPOINTS MESSAGES
]] SETPOINTS
]] S1: CONFIGURATION
]] SETPOINTS
]] S2: PROTECTION
]] SETPOINTS
]] S3: PROCESS
]] SETPOINTS
]] S4: CONTROL
]] SETPOINTS
]] S5: MONITORING
]] SETPOINTS
]] S6: FACTORY DATA
] MOTOR PROTECTION
] THERMAL
] MOTOR PROTECTION
] GROUND FAULT
] MOTOR PROTECTION
] OPTIONS
] LOAD PROTECTION
]
] UNDER/OVERVOLTAGE
] PROTECTION
] COMMUNICATION
]
] MOTOR
] IDENTIFICATION
] STARTER
]
] CT/VT INPUTS
]
] THERMISTOR
]
] FAULT MODE
]
] STATISTICS
]
] PROGRAMMABLE
] MESSAGES
] PREFERENCES
]
] UNDERVOLTAGE
] AUTO RESTART
] AUX RELAY 1 CONFIG
]
] AUX RELAY 2 CONFIG
]
] PLANT CONDITION
]
] PRESET COUNTERS
] AND TIMERS
] PRODUCT FIRMWARE
] IDENTIFICATION
] PRODUCT MODEL
] IDENTIFICATION
] FACTORY SEVICE
] DATA
] PROGRAMMABLE
] INPUTS
] PROCESS INTERLOCK
] NAMES
] STOP CONFIGURATION
]
] ANALOG INPUT
]

GE MOTOR MANAGER 2 Specifications

General

Brand	GE
Model	MOTOR MANAGER 2
Category	Controller
Language	English