CHAPTER 6: SOFTWARE ENERVISTA PQM SETUP INSTALLATION
PQM POWER QUALITY METER – INSTRUCTION MANUAL 6–5
If EnerVista PQM Setup is being upgraded, then note the exact path and directory name of
the current installation as it will be required during the new installation process. Follow the
procedure below to install EnerVista PQM Setup.
Z With windows running, insert the GE Multilin Products CD into the
local CD-ROM drive or go to the GE Multilin website at
www.GEmultilin.com.
If the CD does not autostart, use your web browser to open the file
index.htm in the Products CD root directory.
Z Select the “Software” link and choose “PQM Power Quality Meter”
from the list of products.
Z Click on “EnerVista PQM Setup Version 3.xx” and save the
installation program to the local PC.
Z Start the EnerVista PQM Setup installation program by double-
clicking its icon.
The installation program will request whether or not you wish to
create a 3.5” floppy disk set as shown below.
If so, click on the
Start Copying button and follow the instructions.
If not, click on
CONTINUE WITH EnerVista PQM Setup
VERSION 3.50 INSTALLATION.
Z Enter the complete path including the new directory name
indicating where EnerVista PQM Setup program is to be installed
(see below).
Z If an earlier version of EnerVista PQM Setup has been installed and
is to be upgraded, enter the complete path and directory name of
its current location on the local PC.
The installation program will automatically update the older files.
Z Click on
Next to begin the installation.
The files will be installed in the directory indicated and the
installation program will automatically create icons and add
EnerVista PQM Setup to the Windows start menu.
Z Click
Finish to end the installation.
Courtesy of NationalSwitchgear.com
To Next Page
Loading...
