GE Multilin PQM - 4.3.2 Analog Outputs (Optional)

4–24 PQM POWER QUALITY METER – INSTRUCTION MANUAL
S2 SYSTEM SETUP CHAPTER 4: PROGRAMMING
4.3.2 Analog
Outputs
]] SETPOINTS
]] S2 SYSTEM SETUP
] ANALOG OUTPUT 1
]
ANALOG OUTPUT RANGE:
4-20mA
ANALOG OUTPUT 1 MAIN
NOT USED
MAIN 4 mA VALUE:
0
]] SETPOINTS
]] S3 OUTPUT RELAYS
SETPOINT
Range: 0 - 20 mA,4-20mA
see ANALOG OUTPUT
PARAMETERS table
MAIN 20 mA VALUE:
0
ANALOG OUTPUT 1 ALT:
NOT USED
ALT 4 mA VALUE:
0
ALT 20 mA VALUE:
0
] CURRENT/VOLTAGE
] CONFIGURATION
] ANALOG OUTPUT 2
]
ANALOG OUTPUT 2 MAIN
NOT USED
MAIN 4 mA VALUE:
0
MAIN 20 mA VALUE:
0
ANALOG OUTPUT 2 ALT:
NOT USED
ALT 4 mA VALUE:
0
ALT 20 mA VALUE:
0
CONTINUED ON NEXT PAGE
see ANALOG OUTPUT
PARAMETERS table
see ANALOG OUTPUT
PARAMETERS table
see ANALOG OUTPUT
PARAMETERS table
see ANALOG OUTPUT
PARAMETERS table
see ANALOG OUTPUT
PARAMETERS table
see ANALOG OUTPUT
PARAMETERS table
see ANALOG OUTPUT
PARAMETERS table
see ANALOG OUTPUT
PARAMETERS table
see ANALOG OUTPUT
PARAMETERS table
see ANALOG OUTPUT
PARAMETERS table
see ANALOG OUTPUT
PARAMETERS table
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
Courtesy of NationalSwitchgear.com